Natural Gas Detector, Gas Leak Alarm Sensor Butane Methane Gas Monitor, Voice Prompt, Strobe Light Warning, Digital Display (Gold)

Price: $29.99
(as of May 29, 2024 17:24:35 UTC – Details)

Product Description

Due to the different gas densities, the installation position will be different, please refer to the instructions.

Warming Tip: It takes about one minutes to enter the warm-up state after power on. Please do not press any key during this period.

The gas stove may not lit at the moment when it is turned on, then some gas leaks out and the gas is added with “odorant”, so the taste is very heavy, but the uniform concentration of the leaked gas is far from the alarm standard. Our gas inspector only alarms when the gas concentration reaches 5% LEL. Below this value, it will not explode nor cause any harm to the human body.

Our gas alarms are certified to EN50194, EN60950 and LVD, and each product is 100% inspected in a real gas distribution box and sent to the customer only after passing the inspection.

Home Safety

Never again FORGET to leave the stove on with this new, innovative, combustible gas alarm with continuous monitoring. Protect your family from suffocation dangers and your home from explosive hazards with this device.

Detection levels ranges from 0% to 20% of LEL for multiple combustible gases including methane, propane, butane, coal gas, town gas, LPG Liquid Petroleum Gas, LNG Liquid Natural Gas.

Visual Warning:

– Green: System is on, Electric connection. – Yellow: Fault, Sensor has lost efficacy. – Red: Alarm, Gas Leakage.

Warm-up Time: 1 minute Audible Warning: Buzzer Alarm Set Point: 5%LEL Alarm Tolerance: ±3%LEL Working temperature: 0℃ to 55°C Sensor Type: Catalytic Environment humidity: ≤95% RH 100*100*25mm

Product Specifications:

Area of Usage: Household, Camper, or Portable via micro USB power supply
Static Current: ＜110mA @ 5V Power Consumption: <0.55W Response Time: ≤30 seconds Loudness Level: 85dB (from the distance of 1 meter) Operating Voltage: DC5V±10% 1A Backup Battery: 3.7V rechargeable battery Battery Standby Time: 4~6 hours Body Material: ABS, Metal

Package Contents:

1 x Gas Detector (With Rechargeable Battery)

2 x Screws

2 x Screw Stoppers

1 x User Manual

1 x Charger

1 x USB Cable

Maintenance points of the gas detector:

1. Avoid placement in close proximity to where airborne contaminants like cooking oils can coat and decrease sensor sensitivity.

2. Users may clean exterior surface of the detector, unplug the device before cleaning.

3. Never use chemical substances such as spray, polish, detergent etc.

How to install?

Natural gas is comprised of methane gas that is lighter than air. In case of gas leakage; gas rises towards ceiling and accumulates in areas near ceiling. Therefore, for natural gas, the detector shall be located in a position of 30cm under the ceiling and 1.5-4 meter(s) away from gas supply.

LPG is comprised of mixture of propane and butane that is heavier than air. In case of gas leakage, LPG falls down to ground. Therefore, for LPG, the detector shall be located in a position of 30 cm above the floor and 1.5-4 meter(s) away from gas supply.